S. Gokyer Erbis*, W. Marr, T. Bardainne, R. Tarnus
Surface wave tomography is a feasible method to provide complementary data to better understand the continuity of soil strata. It may also be used to determine best locations for invasive testing. Surface wave tomography methods are frequently used to delineate soil-rock interface and determine average shear wave velocity for seismic site class determination. Delineation within the soils layers where the change in seismic velocity within the soil layers are relatively small requires higher resolution data collection and enhanced processing methods than those used historically in surface wave tomography. This study uses a patented imaging and monitoring system based on the passive seismic interferometry technique augmented by active seismic sources at known locations. A dense nodal array of MEMs accelerometers were deployed at a site where known saturated loose materials exist. This paper presents shear wave velocity (Vs) data deduced from surface wave measurements where various, compression wave velocity (Vp) to Vs ratios were considered, especially showing the effect of Vp/Vs ratio, on the Vs data. This ratio which was traditionally assumed can have a significant effect on the inferred Vs. This paper also presents the comparison of deduced Vs data to measured Vs data by seismic cone penetration test and makes some recommendations for how to improve the methods to determine shear wave velocity in soft/loose soils.
Keywords:
Published on 06/06/24Submitted on 06/06/24
Volume Advances in geophysical ground characterization, 2024DOI: 10.23967/isc.2024.255Licence: CC BY-NC-SA license
Views 0Recommendations 0
Are you one of the authors of this document?