| Line 3: | Line 3: | ||
In this paper, the effects of types of concrete release agent, the amount of brushing per unitarea and the 1d's strength of concrete on the release performance were studied. The adhesion and filmforming ability of O/W emulsion release agent was improved by adding high polymer. The results showthat the 1d's strength of concrete has no effect on the release performance of the release agent. The mostimportant factors affecting the release performance are brushing amount per unit area and the type ofrelease agent. O/W emulsion release agent with polyacrylamide and polyethylene glycol all stick mold. The more they are added, the heavier the stickiness is. While, the release performance with polyethyleneglycol is very close to blank sample. | In this paper, the effects of types of concrete release agent, the amount of brushing per unitarea and the 1d's strength of concrete on the release performance were studied. The adhesion and filmforming ability of O/W emulsion release agent was improved by adding high polymer. The results showthat the 1d's strength of concrete has no effect on the release performance of the release agent. The mostimportant factors affecting the release performance are brushing amount per unit area and the type ofrelease agent. O/W emulsion release agent with polyacrylamide and polyethylene glycol all stick mold. The more they are added, the heavier the stickiness is. While, the release performance with polyethyleneglycol is very close to blank sample. | ||
| + | |||
| + | == Full Paper == | ||
| + | <pdf>Media:Draft_Sanchez Pinedo_633652018118.pdf</pdf> | ||
Revision as of 11:36, 3 October 2023
Abstract
In this paper, the effects of types of concrete release agent, the amount of brushing per unitarea and the 1d's strength of concrete on the release performance were studied. The adhesion and filmforming ability of O/W emulsion release agent was improved by adding high polymer. The results showthat the 1d's strength of concrete has no effect on the release performance of the release agent. The mostimportant factors affecting the release performance are brushing amount per unit area and the type ofrelease agent. O/W emulsion release agent with polyacrylamide and polyethylene glycol all stick mold. The more they are added, the heavier the stickiness is. While, the release performance with polyethyleneglycol is very close to blank sample.
Full Paper
Document information
Published on 03/10/23
Submitted on 03/10/23
DOI: 10.23967/c.dbmc.2023.118
Licence: CC BY-NC-SA license
Share this document
Keywords
claim authorship
Are you one of the authors of this document?