m (Scipediacontent moved page Draft Content 127598321 to Korzekwa et al 2021a) |
|||
| Line 1: | Line 1: | ||
== Abstract == | == Abstract == | ||
| − | The article discusses the process of preparing samples with an anodic Al | + | The article discusses the process of preparing samples with an anodic Al<sub>2</sub>O<sub>3</sub> layer for tribological tests in the combination of sliding, reciprocating on the T17 tester. The method of cutting, grinding, drilling, threading, gluing, etching, and anodizing samples used in laboratory conditions was presented. As shown in the article, the number of factors influencing the surface quality of the oxide layer produced in terms of tribological associations is |
| + | significant; therefore, the appropriate sample preparation methodology is so important. | ||
== Full document == | == Full document == | ||
<pdf>Media:Draft_Content_127598321p5116.pdf</pdf> | <pdf>Media:Draft_Content_127598321p5116.pdf</pdf> | ||
Latest revision as of 08:35, 12 March 2021
Abstract
The article discusses the process of preparing samples with an anodic Al2O3 layer for tribological tests in the combination of sliding, reciprocating on the T17 tester. The method of cutting, grinding, drilling, threading, gluing, etching, and anodizing samples used in laboratory conditions was presented. As shown in the article, the number of factors influencing the surface quality of the oxide layer produced in terms of tribological associations is significant; therefore, the appropriate sample preparation methodology is so important.
Full document
Document information
Published on 10/03/21
Submitted on 10/03/21
Volume 1000 - Manufacturing and Materials Processing, 2021
DOI: 10.23967/wccm-eccomas.2020.293
Licence: CC BY-NC-SA license
Share this document
Keywords
claim authorship
Are you one of the authors of this document?