(Created blank page) |
m (JSanchez moved page Draft Sanchez Pinedo 209900858 to Gallego-Bordallo et al 2023a) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | |||
| + | ==Abstract== | ||
| + | In this study, a method is presented to design embedded cooling channels in an additively manufactured metal part. A fluid flow-based Topology Optimization (TO) methodology was applied on a specific industrial case study with thermal objectives and constraints. The resulting design was 3D-printed and assessed numerically. In addition, the cooling efficiency is compared against that of the original design, which is machined. This work was performed using commercial software tools Simcenter STAR-CCM+ to perform the thermal and fluid flow optimization and simulations; NX to generate a final geometry from optimization results and 3DXpert to assess part printability. | ||
| + | |||
| + | == Full Paper == | ||
| + | <pdf>Media:Draft_Sanchez Pinedo_209900858pap_38.pdf</pdf> | ||
Latest revision as of 13:16, 16 November 2023
Abstract
In this study, a method is presented to design embedded cooling channels in an additively manufactured metal part. A fluid flow-based Topology Optimization (TO) methodology was applied on a specific industrial case study with thermal objectives and constraints. The resulting design was 3D-printed and assessed numerically. In addition, the cooling efficiency is compared against that of the original design, which is machined. This work was performed using commercial software tools Simcenter STAR-CCM+ to perform the thermal and fluid flow optimization and simulations; NX to generate a final geometry from optimization results and 3DXpert to assess part printability.
Full Paper
Document information
Published on 16/11/23
Submitted on 16/11/23
DOI: 10.23967/c.simam.2023.004
Licence: CC BY-NC-SA license
Share this document
Keywords
claim authorship
Are you one of the authors of this document?